Pile Drivers

Pile Drivers

Products

SUNWARD KOREA CO., LTD.

Hydraulic Crawler Pile Driver
SWCH680H-155M
Please refer to the above performance table when using the pile driver.
Depending on site conditions and work methods,
attachments can be exchanged within the allowable capacity of the pile driver.
Exceeding the specified capacity may be hazardous, so please take caution.
- The allowable traveling maximum weight is 153 tons.
- Please use within allowable maximum torque,
  allowable maximum digging distance, and allowable maximum pulling force.
  (For detailed information, refer to the operator’s manual.)
- Using a leader longer than 40M is hazardous, so please be careful.
- Exceeding the weight limit may be dangerous, so always exercise caution.
- Always maintain the equipment clean and check the equipment before and after use.
  (This helps prevent engine, cylinder, and hydraulic line failures.)
- For filters and other consumables, follow the recommended replacement intervals.
- Please use high-quality fuel to avoid starting issues or engine damage.
- Specifications may change due to the manufacturer’s circumstances.

Item		Unit	Specification	Remarks
Engine (Cummins)	Model	-	B6.7	CUMMINS STAGES
	Rated Power	kW/rpm	186/2000
	Maximum Torque	N·m/rpm	1152/1500
Leader /Backstay	Rear Length/Diameter	m/Ø	40 / Ø720
	Main Guide	mm	Ø102X600
	Auxiliary Guide	mm	Ø70X330
	Backstay Diameter	Ø	Ø478
	Front/Rear Inclination	°	±7	Slope Operation
	Left/Right Safety Angle	°	±1.5
	Allowable Maximum Pulling Force	kN(t)	588(60)
Drum 1	Line Speed	m/min	96	Free Fall
	Rope Diameter/Length	mm/m	20/540
	Line Tension	ton	11
Drum 2	Line Speed	m/min	96	Free Fall
	Rope Diameter/Length	mm/m	20/420
	Line Tension	ton	11
Drums 3/4	Line Speed	m/min	40	Free Fall
	Rope Diameter/Length	mm/m	20/100
	Line Tension	ton	12
Leader Rewind Drum	Line Speed	m/min	19
	Rope Diameter/Length	mm/m	22/226
	Line Tension	ton	9
Hoist Drum	Line Speed	m/min	6.4
Hoist Drum	Rope Diameter/Length	mm/m	14/110
Chassis	Track Extended	mm	4760/4860
	Track Retracted	mm	3300/3400
	Track Width	mm	800/860
	Track Length	mm	6070
	Distance Between Tumblers	mm	5165
	Travel Speed	km/h	1
	Climbing Ability	°	7
Counterweight		ton	15
Chassis Weight		ton	65.8	Without Leader, Backstay, and Counterweight
Ground Contact Area		m²	8.77
Ground Pressure		MPa	0.174
Allowable Maximum Traveling Weight		ton	153	Including Attachments

Note) Leader Combination

- Based on the length at the top of the holder, the assembly order can be adjusted according to field conditions without affecting safety.

Leader	Attachment								Hammer				Generator Weight (t)	Safety Angle (No Pile)		Total Weight (No Pile) (t)	Average Ground Pressure (No Pile)
Length (m)	Upper Auger		Lower Auger		Screw		Casing		Model	Weight (t)	Cap Weight (t)	Auxiliary Leader Weight (t)		Safety Angle (No Pile)			Average Ground Pressure (No Pile)
Length (m)	Model	Weight (t)	Model	Weight (t)	Length (m)	Weight (t)	Length (m)	Weight (t)	Model	Weight (t)	Cap Weight (t)	Auxiliary Leader Weight (t)		Front/Rear	Left/Right		MPa	Kg/cm²
40	JUA-150P	7.3	JLA-150P	8.5	36	7.2	33	4.554	JC70	7.2	0.2	1.1	5.594	8.8	10.9	152.933	171	1.74
37	JUA-150P	7.3	JLA-150P	8.5	33	6.6	30	4.140	JC70	7.2	0.2	1.1	5.594	9.7	11.6	150.743	169	1.72
34	JUA-150P	7.3	JLA-150P	8.5	30	6.0	27	3.726	JC70	7.2	0.2	1.1	5.594	10.9	12.7	148.168	166	1.69
31	JUA-150P	7.3	JLA-150P	8.5	27	5.4	24	3.312	JC70	7.2	0.2	1.1	5.594	12.2	13.8	145.838	163	1.66
28	JUA-150P	7.3	JLA-150P	8.5	24	4.8	21	2.898	JC70	7.2	0.2	1.1	5.594	13.7	15.2	143.458	160	1.64
25	JUA-150P	7.3	JLA-150P	8.5	21	4.2	18	2.484	JC70	7.2	0.2	1.1	5.594	15.6	16.7	140.933	158	1.61
22	JUA-150P	7.3	JLA-150P	8.5	18	3.6	15	2.070	JC70	7.2	0.2	1.1	5.594	17.7	18.5	138.553	155	1.58